Home - Brands - Bilstein
Additional Images

Bilstein 6112 Height Adjustable Front Shock and Coil Pair for 1996-2002 4Runner (47-258624)

BIL 47-258624

Designed for the serious off-road adventure seeker, the all-new BILSTEIN 6112 Series is the ultimate suspension solution. The 6112 Series optimizes off-road and on-road capabilities with a specially tuned performance coil matched with a monotube damper featuring a massive 60mm digressive piston for increased damping control. This kit features an adjustable spring seat which allows vehicle leveling, larger tires, and increased ground clearance. These units require your existing strut upper mount plates. They come with upper stem cushions and upper/lower cushion washers. If you don’t want to disassemble your factory struts to get these pieces we have all of them available separately. Optionally, we can assemble these struts for you so that they’re ready to bolt in. We have 5100 rear shocks available to complete your setup.

Bilstein advises that these are good for 0-2.3? lift with the supplied coils. These include 600LB rate coils. Optionally (available separately at an additional charge), we have 650LB and 700LB coils for these as well.

 WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Was: $732.00
Sale: $699.00
Save: 5%
Save: $33.00


  • Large 60mm monotube for increased oil capacity, cooling, and long-term durability
  • 60mm digressive piston for improved ride comfort and control over rough terrain
  • Custom engineered cold wound linear springs for enhanced vehicle control
  • Monotube design for consistent, fade-free performance
  • Application specific for maximum performance
  • Reuses OEM top mount and rubber isolator
  • Made in the USA


  • (2) front 60mm shocks
  • (2) spring seats
  • (2) springs


  • Limited Lifetime Warranty
**Note: These shocks may only be used for specific applications. Due to the variations in lift kit manufacturers’ systems, it is the responsibility of the installer/end user to confirm that the shocks are dimensionally correct. Most lift kits require lowered bump stops to compensate for longer shocks mounted into the OEM location. BILSTEIN will not be liable for damage caused by a full compression impact of the shock absorber.


5100 Series Monotube Shock Absorbers:

Monotube vs. Twintube:

How are BILSTEIN Shock Absorbers made:

Shipping Information

  • Item Requires Shipping
  • 43.0 lbs.
  • W32.0000” x H18.0000” x L8.0000”
  • This item ships in its own box.