Home - Return to Previous Page
Additional Images

6112 Height Adjustable Front Shock Set for 2007+ Tundra (46-206084)

BIL 46-206084

Designed for the serious off-road adventure seeker, the all-new BILSTEIN 6112 Series is the ultimate suspension solution. The 6112 Series optimizes off-road and on-road capabilities with a specially tuned performance coil matched with a monotube damper featuring a massive 60mm digressive piston for increased damping control.

The shock absorbers included in the BILSTEIN B8 6112 kit come equipped with an adjustable spring seat— perfect for leveling your vehicle, increasing ground clearance, and installing larger tires. These units require your existing strut upper mount plates, stem cushions and washers. If you don't want to disassemble your factory struts to get these pieces we have all of them available separately. Optionally, we can assemble these struts for you so that they're ready to bolt in. We have 5100 and 5160 rear shocks available to complete your setup.

4/15: During assembly of a pair of these new front struts we found that Bilstein has packaged their first production run with stud nuts that have the wrong thread pitch (12X1.25 instead of 12X1.5). Wheeler's will make sure that the shocks that we ship to you have the correct nuts.

Was: $789.00
Sale: $659.00
Save: 16%
Save: $130.00


  • Lifted Height: .75"-2.5"
  • Large 60mm monotube for increased oil capacity, cooling, and long-term durability for improved ride comfort and control over rough terrain
  • Custom engineered cold wound linear springs for enhanced vehicle control
  • Monotube design for consistent, fade-free performance
  • Application specific for maximum performance
  • Reuses OEM top mount and rubber isolator
  • Available for late model trucks and SUVs which utilize a front coilover suspension
  • Made in the USA


  • (2) 60mm Shock Absorbers
  • (2) Billet Hard Anodized Spring Seats
  • (2) Springs


  • Limited Lifetime Warranty
**Note: These shocks may only be used for specific applications. Due to the variations in lift kit manufacturers’ systems, it is the responsibility of the installer/end user to confirm that the shocks are dimensionally correct. Most lift kits require lowered bump stops to compensate for longer shocks mounted into the OEM location. BILSTEIN will not be liable for damage caused by a full compression impact of the shock absorber.


Bilstein - 6112 Series:

Monotube vs. Twintube:

How are BILSTEIN Shock Absorbers made:

Shipping Information

  • Item Requires Shipping
  • 52.0 lbs.
  • W12.0000” x H12.0000” x L28.0000”